Siemens SINUMERIK 808D Programming And Operating Manual

Typical turning program
Turning Part 2: Programming (Siemens instructions)
204 Programming and Operating Manual, 05/2012, 6FC5398-5DP10-0BA0
Turning part program example2
The following is another example of the turning part program:
N10 G54G00 G90 G95 G40 G71
N20 LIMS=4500
N30 T1 D1
N40 G96 S250 M03 M08
N50 G00 X35 Z0
N60 G01 X-2 F0.35
N70 G00 Z2
N80 G00 X35
N90 T13 D1
N100 G95 S1000 M4
N110 G00 Z1 X0
N120 CYCLE83( 10.00000, 0.00000, 2.00000, -23.00000, 0.00000, -10.00000, ,5.00000, ,
,1.00000, 0, 1, 5.00000, 0.00000, ,0.00000)
N130 G18
N140 T10 D1
CYCLE95( "CON1:CON1
_
E", 1.50000, 0.20000, 0.10000, ,0.50000, 0.30000, 0.20000, 11, ,
,)
N30 T110 D1
N40 G96 S250 M03 M08
N50 G00 Z1 X0
N60 G1 F0.3 Z-17
CYCLE93( 16.00000, -17.00000, 4.00000, 3.00000, , , , , , , , , ,1.00000, ,13, )
N150 M30
;*************CONTOUR************
CON1:

Siemens SINUMERIK 808D Specifications

General

Brand	Siemens
Model	SINUMERIK 808D
Category	Control Unit
Language	English