03.06
iv
© Siemens AG, 2006. All rights reserved
SINUMERIK 840D Configuring Manual NCU (PHD) – 03.06 Edition
Asia and Australia time zone
A&D Technical Support
Tel.: +86 1064 719 990
Fax: +86 1064 747 474
Internet: http://www.siemens.com/automation/support-request
E-mail: mailto:adsupport@siemens.com
America time zone
A&D Technical Support
Tel.: +1 423 262 2522
Fax: +1 423 262 2289
Internet: http://www.siemens.com/automation/support-request
E-mail: mailto:adsupport@siemens.com
Note
Country-specific telephone numbers for technical support are provided under
the following Internet address:
http://www.siemens.com/automation/service&support
For questions on the documentation (suggestions, corrections), please send a
fax or e-mail to the following address:
Fax: +49 (0) 9131 / 98 - 63315
E-mail: mailto:motioncontrol.docu@siemens.com
Fax form: See the reply form at the end of the brochure
http://www.siemens.com/sinumerik
The EC conformity declarations on EMC are to be found at/can be obtained
from:
In the Internet:
http://www.ad.siemens.com/csinfo
under the product/order no. 15257461
At the relevant branch office of the A&D MC group of Siemens AG.
This manual contains information which you should observe in order to ensure
your own personal safety, as well to avoid material damage. Notices which are
relevant to your own personal safety are highlighted by a safety alert symbol;
notices which are relevant only to equipment and property damage have no
safety alert symbol. The warnings appear in decreasing order of risk as given
below.
!
Danger
Indicates that death or serious injury will result if proper precautions are not
taken.
Questions about
the manual
SINUMERIK
Internet address
EC Conformity
Declaration
Safety information
Preface
To Next Page
Loading...
Need help?
General
