03.06
v
© Siemens AG, 2006. All rights reserved
SINUMERIK 840D Configuring Manual NCU (PHD) – 03.06 Edition
!
Warning
Indicates that death or serious injury may result if proper precautions are not
taken.
!
Caution
With a safety alert symbol, indicates that minor personal injury may result if
proper precautions are not taken.
Caution
Without a safety alert symbol, indicates that property damage can result if
proper precautions are not taken.
Notice
Indicates that an undesirable event or state may arise if the relevant notes are
not observed.
If several hazards of different degrees occur, the hazard with the highest degree
must always be given priority. If a warning note with a warning triangle warns of
personal injury, the same warning note can also contain a warning of material
damage.
Startup and operation of the device / equipment / system in question must only
be performed using this documentation. Only qualified personnel should be
allowed to commission and operate the device/system. Qualified persons are
defined as persons who are authorized to commission, to ground, and to tag
circuits, equipment, and systems in accordance with established safety prac-
tices and standards.
Please note the following:
!
Warning
The equipment may only be used for single purpose applications explicitly
described in the catalog and in the technical description and it may only be
used along with third-party devices and components recommended by
Siemens. To ensure trouble-free and safe operation of the product, it must be
transported, stored and installed as intended and maintained and operated with
care.
Qualified
personnel
Proper use
Preface
To Next Page
Loading...
Need help?
General
