B.2.2.2 Mounting on linear actuator up to 14 mm (0.55 inch)
Requirement
1. An Analog Input Module (AIM) built into the positioner.
2. An NCS for linear actuators up to 14 mm (0.55 inch) 6DR4004-.N.20.
3. A linear actuator with interface to NAMUR. This installation must be carried out individually.
Only a NAMUR mounting bracket can be used as mounting base. The following figure
shows the assembly with NAMUR mounting bracket. Or:
A linear actuator without interface to NAMUR and individual mounting solution.
External position detection
B.2 Non-Contacting Sensor
SIPART PS2 with 4 to 20 mA/HART
276 Operating Instructions, 11/2019, A5E00074631-AE
To Next Page
Loading...
Need help?
General
