Siemens sitrans PROBE LU - Page 68

Page 62 SITRANS Probe LU (PROFIBUS PA) – INSTRUCTION MANUAL 7ML19985JB02
mmmmm
G: Data Map
1 ST REV r Value UNSIGNED_INTEGER(2)
2 Tag r/w Value ASCII(32)
3 Strategy r/w Value UNSIGNED_INTEGER(2)
4 Alert Key r/w Value UNSIGNED_INTEGER (1)
5 Target Mode r/w Value UNSIGNED_INTEGER (1)
6Mode Blockr
Actual Mode UNSIGNED_INTEGER (1)
Permitted Modes UNSIGNED_INTEGER (1)
Normal Mode UNSIGNED_INTEGER (1)
7 Alarm Summary r
Current States UNSIGNED_INTEGER (1)
Unacknowledged UNSIGNED_INTEGER (1)
Unreported UNSIGNED_INTEGER (1)
Disabled UNSIGNED_INTEGER (1)
8 Software Revision r Value ASCII(16)
9 Hardware Revision r Value ASCII(16)
10 Manufacturer ID r Value UNSIGNED_INTEGER (2)
11 Device ID r Value ASCII(16)
12 Serial Number r Value ASCII(16)
13 Diagnosis r Value UNSIGNED_INTEGER (4)
14 Diagnosis Extension r Value BYTE (6)
15 Diagnosis Mask r Value UNSIGNED_INTEGER (4)
16 Diagnosis Ext Mask r Value BYTE (6)
17 Certification r Value ASCII(32)
18 Write Locking r/w Value UNSIGNED_INTEGER(2)
19 Factory Reset r/w Value UNSIGNED_INTEGER(2)
20 Descriptor r/w Value ASCII(32)
21 Device Message r/w Value ASCII(32)
22 Installation Date r/w Value ASCII(16)
23
Local Operation
Enable
r/w Value UNSIGNED_INTEGER (1)
24 PROFIBUS Ident r/w Value UNSIGNED_INTEGER (1)
26
Features Supported r Value INTEGER (4)
Features Enabled r/w Value INTEGER (4)
27
Condensed Status
Mode
r/w Value INTEGER (1)
28
Condensed Status
Setup
r/w Value Byte array (50)
42 Order Number r ASCII (32)
Relative
Index
Name Access Structure Type (cont’d)