Sify SMAC Series - IP Filtering

SMAC User Manual
Sify Technologies Limited, 2011 © Copyright Protected Page 32
Enable/Disable
Select Enable or Disable function from the drop down list.
Drop All L2 Multicast
Select Enable or Disable function from the drop down list. By default
it’s disabled.
Drop All L3 Multicast
Select Enable or Disable function from the drop down list. . By
default it’s enabled.
Drop All L2 Broadcast
Select Enable or Disable function from the drop down list. By default
it’s disabled.
Drop All L3 Broadcast
Select Enable or Disable function from the drop down list. . By
default it’s disabled.
Filtering Type
Select White list/Blacklist from the drop down list.
Black list – By default all the data traffic is allowed, it will block the
traffic based on the filter rule is applied.
White list – By default all the data traffic is blocked, it will allow the
traffic based on the filter rule is applied.
Note
All the filter related changes will take effect immediately after
clicking on ‘accept’ tab.
8.0.2 IP Filtering
IP
Specify the IP address.
MASK
Specify the IP sub mask.
SOURCE IP
Specify the Source IP address.
SOURCE MASK
Specify the Source sub mask.
DESTINATION IP
Specify the Destination IP address
DESTINATION MASK
Specify the Destination sub mask
Protocol
Specify the protocol name