Sigma 4-15C - Operating Elements; Operation

Operating Manual SIGMA 4-15C, page 8 of 95
03/06
Operating Elements
4.1 Operating panel
4.1.1 Start-key
4.1.2 Stop-key
4.1.3 Lid-key
4.1.4 Knob
4.2 Display
4.2.1 Set
4.2.2 Speed
4.2.3 Relative Centrifugal Force (RCF)
4.2.4 Time
4.2.5 Program
4.2.6 Rotor
4.2.7 Parameters
4.2.7.1 Acceleration
4.2.7.2 Deceleration
4.2.7.3 Radius
4.2.7.4 Density
4.2.7.5 Start delay
4.2.7.6 Automatic lid opening after end of run
4.2.8 Configuration
Operation
5.1 Selection, display and alteration of program parameters
5.1.1 Selection and alteration of the parameters and activation of the start
delay and the automatic lid opening after end of run
5.1.2 Selection and alteration of the rotor part number
5.1.3 Alteration of the parameter values during the centrifuge run
5.1.4 Alteration of the configuration
5.1.4.1 Curves
5.1.4.2 Creation of curves for variable accelerations and decelerations
5.1.4.3 Alteration of existing curves
5.1.5 Alteration of the contrast
5.1.6 Imbalance monitoring
5.1.7 Shortrun and faststop
Programming
6.1 Load, save and delete programs
6.1.1 Load a program
6.1.2 Save a program
6.1.3 Delete a program