Sigma FP - TO INSERT THE CARD

41
TO INSERT THE CARD
1
Make sure that the power switch is set to
OFF. Rotate the battery/SD card cover
latch to open the cover.
2
Insert the card as per the instructions.
 Insert the card until it clicks.
3
Close the battery compartment cover and
lock the cover by turning the battery/SD
card cover latch.
TO REMOVE THE CARD
Push the card in until it clicks and then pull
it out straight.
WARNING!!
 While the Busy Lamp is on or flashing, do not take out the battery or the
card. By doing so, it may result in data loss. This could also cause
damage to the camera and/or memory card.
TIP
 If the camera is turned off while the Busy Lamp is on or flashing, the
camera will remain on until it has finished accessing the card.