Sigma ROX 5.0 - Resetting the Synchronization

Synchronizing the transmitters
Attaching the ROX 5.0 and initial use
Page 12
ROX 5.0
www.sigmasport.com
ROX 5.0
2.8.4 Resetting the synchronization
If a transmitter does not display any values or the wrong transmitter is
synchronized, the synchronization can be reset.
1 Press and hold the
Mode 1
button for three seconds.
‘Sync. RESET’ flashes on the display.
2 The zeros of the speed, cadence, and heart rate values flash again while
the respective transmitters are being synchronized.
Mode 1