ROX 5.0
4.16 Setting the total running calories
You can use this option to enter existing values (e.g. transferred from your old
device). New values are then added to these.
1 Press the
Mode 1
button to switch to the total running calories.
2 Press the
Set
button. The first digit for entry flashes.
3 Press
Mode 2
or
Reset
to increase or decrease the value respectively.
4 Press the
Mode 1
button to switch to the next digit.
5 Press the
Set
button to save your setting.
‘Set OK’ appears on the display.
4.17 Activating the zone alarm
1 Press the
Mode 1
button to switch to the zone alarm.
2 Press the
Set
button. The current setting flashes.
3 Press
Mode 2
or
Reset
to switch the zone alarm on or off respectively.
4 Press the
Set
button to save your setting.
‘Set OK’ appears on the display.
Note
The zone alarm beeps during your ride if you are outside the limits of the selected
training zone.
4.18 Setting the contrast
1 Press the
Mode 1
button to switch to the preset contrast.
2 Press the
Set
button. The display flashes.
3 Press
Mode 2
or
Reset
to increase or decrease the value respectively.
(1=weak/3=strong)
4 Press the
Set
button to save your setting.
‘Set OK’ appears on the display.
Set Mode 1
Mode 2
Reset
Set Mode 1
Mode 2
Reset
Set Mode 1
Mode 2
Reset
To Next Page
Loading...
Need help?
General
