SIGMATEK C-DIAS - Page 31

C-DIAS PROCESSOR MODULE CCP 611
27.03.2020 Page 29
25
DIAS ERROR
While accessing a DIAS module, an
error has occurred.
Possible Causes:
- An attempt is made to access a
nonexistent DIAS module.
- DIAS bus error.
Solution:
- Check the DIAS bus
- Check the termination resistors.
26
WAIT
The CPU is busy.
27
OP PROG
The operating system is currently
being reprogrammed.
28
OP INSTALLED
The operating system has been
reinstalled.
29
OS TOO LONG
The operating system cannot be
loaded; too little memory.
30
NO OPERATING
SYSTEM
Boot loader message.
No operating system found in RAM.
31
SEARCH FOR OS
The boot loader is searching for the
operating system in RAM.
32
NO DEVICE
33
UNUSED CODE
34
MEM ERROR
The operating system loaded does
not match the hardware configura-
tion.
35
MAX IO
36
MODULE LOAD
ERROR
The LASAL Module or project
cannot be loaded.
37
GENERELLER BS-
FEHLER
A general error has occurred while
loading the operating system.
38
APPLMEM ERROR
An error has occurred in the applica-
tion memory (user heap).
39
OFFLINE
40
APPL LOAD
41
APPL SAVE