AFTER SALES SUPPORT
1300 777 137
service@unclebills.com.au
MODEL: EA2306 PRODUCT CODE: 713007 08/2023
12
4. Fit the dual hook and loop pad earphone mounts
to the inside (internal padding) of your helmet. It
is suggested to put one on either side closest to
your ears. Once you have found the correct position
for the earphone mounts, put the felted adhesive
pads (for speakers) in its place, remove the adhesive
sticker and apply to the inside of your helmet.
5. Once you have tted both felted adhesive pads (for speakers) to the
inside of your helmet, attach the hook and loop earphone mounts to the
felted pads.
6. For your convenience two different options of microphones have been
included. Position the microphone of choice to the left side of your helmet
along the inside wall, closest to the headset and near your mouth.
NOTE: For the wired boom microphone, the felted adhesive pad is
already attached to the microphone. Simply peel the sticker and attach
the wired boom microphone to the inside of the helmet. For the other
microphone, use one of the two small felted adhesive pads (supplied) to
mount onto the inside of the helmet.
Installation (cont.)
To Next Page
Loading...