AFTER SALES SUPPORT
1300 7 77 137
service@unclebills.com.au
MODEL: EA2476 PRODUCT CODE: 715222 03/2024
19
GETTING STARTED (CONT.)
4. Assemble and secure the stand to the camera mount base (E) (Fig. 6).
5. Place the assembled camera mount over the holes and screw in the screws
(supplied) to secure the camera mount base to the surface.
6. Position the camera mount hole located on the back or bottom of the Wildlife
Camera on the tripod bolt (B). Two separate camera mount holes have been
provided, to increase the flexibility of mounting the Wildlife Camera. Partially secure
the camera by screwing the tripod bolt into the camera (approximately 3-5 turns).
7. Adjust the Wildlife Camera onto your desired alignment and then secure with the
counter screw (C). A spanner may need to be used (not supplied).
8. Release the 2 x hinge screws (D) slightly to adjust the Wildlife Camera into the
final position. Then secure by tightening the 2 x hinge screws (D).
NOTE: If the camera mount is located in a high position, the Wildlife Camera may
need to be angled toward the ground to capture low moving objects. Angling
the camera downwards may affect how much sun hits the solar panel and may
impede solar power charging.
To Next Page
Loading...
