AFTER SALES SUPPORT
1300 7 77 137
service@unclebills.com.au
MODEL: EA2476 PRODUCT CODE: 715222 03/2024
13
GETTING STARTED
Before First Use
Prior to using your Wildlife Camera, please read all safety and operating instructions
thoroughly. Please ensure you follow the steps below before using this device.
1. Unpack the product but keep all packaging materials until you have made sure
your new Wildlife Camera is undamaged and in good working order.
2. Plastic wrapping can be a suffocation hazard for babies and children, so ensure all
packaging materials are kept out of their reach.
3. Remove the protective film from the Wildlife Camera camera lens, LEDs and PIR
sensor by pulling the protruding tab, and dispose of thoughtfully.
4. We recommend you keep the original packaging for storing your Wildlife Camera
when not in use.
NOTE: It is EXTREMELY important that ALL protective film is removed from the
camera lens, LEDs and the sensor. The Wildlife Camera will not function properly if
the film is not removed and the photos and videos will come out blurry.
Opening and Closing the Wildlife Camera
The memory card slot, USB-A to USB-C port, operating buttons and battery
compartment are located inside the protective case of the Camera.
1. To open the protective case, firmly lift each locking tab until they release and open
the Wildlife Camera protective case.
2. To close the protective case, firmly press each locking tab until they 'click' into
position and the camera case is now closed.
NOTE: There is a hole located between the two locking tabs where you can attach a
lock to secure the Wildlife Camera in the closed position to prevent any tampering.
Memory Card Installation
The Wildlife Camera uses a micro SD card for data storage. A memory card must be
inserted in order to take and save photos or video recordings.
Insert the micro SD card (supplied) into the Wildlife Camera before switching ON or
setting up the camera settings.
To Next Page
Loading...