AFTER SALES SUPPORT
1300 7 77 137
service@unclebills.com.au
MODEL: EA2476 PRODUCT CODE: 715222 03/2024
28
INSTRUCTIONS (CONT.)
NOTE: The PIR detection distance will be shorter if the environment temperature
reaches 30˚C or above.
NOTE: Check that the Wildlife Camera is set to the correct height in line with
the point to be observed. Where necessary, point the Wildlife Camera slightly
downwards for optimum alignment.
NOTE: The Wildlife Camera is IP66 weatherproof. The device is protected against
spray water and dust and subsequently can be used outdoors in most weather
conditions.
Live Mode (ON)
The standard application of the Wildlife Camera is in the ON (live) mode. In this mode,
photos and/or video are triggered either by movement (PIR sensors) or at intervals
according to the Wildlife Camera’s settings.
1. Slide the Power/Mode switch to ON.
2. The red LED will flash and the counter on the bottom left of the viewing screen
will count down from around 5 seconds and then the Wildlife Camera viewing
screen will turn off. The Wildlife Camera is now in standby mode.
3. When animals, birds or other moving objects enter the detection range of the
central PIR sensor, the Wildlife Camera will activate and take photos and/or record
the video depending on the camera’s settings.
NOTE: During daytime, the IR LEDs will not light up and the photos and videos
taken will be in colour. At night, the IR LEDs will light up and the photos and videos
taken will be in black and white.
NOTE: It is recommended to set up the desired recording mode and related
parameters in the SETUP (test) mode, before switching the Wildlife Camera to ON
(live) mode.
To Next Page
Loading...
