AFTER SALES SUPPORT
1300 7 77 137
service@unclebills.com.au
MODEL: EA2476 PRODUCT CODE: 715222 03/2024
29
INSTRUCTIONS (CONT.)
NOTE: When the PIR sensitivity is set to ‘Auto’, the Wildlife Camera will adjust the
brightness of the IR LEDs automatically. When shooting at night, the brightness
will be decreased automatically, and the shooting effect will be inferior to that of
daytime shooting. If the built-in battery power drops to 10% and/or the AA Alkaline
battery available power is less than 30%, the Wildlife Camera will not activate at
night.
NOTE: In ON (live) mode at night, the Wildlife Camera will record automatically
as per the video length setting. When the battery power is too low, the Wildlife
Camera will stop recording. It is recommended to select a shorter video length to
preserve the battery power.
Image and Video Recording Modes
Photo and video resolutions can be adjusted using the button. Refer to the
‘Menu Options and Settings’ section on pages 21-25. We have included a table below
as a guide for the quantity of photos or video that can be stored on the 8GB micro SD
Card (included).
NOTE: The micro SD card (supplied) must be inserted into the Wildlife Camera in
order to save photos and video recordings. Refer to the instructions starting on
page 13 for how to install the memory card.
NOTE: Remember, photos and video recordings cannot be taken or saved unless a
micro SD card has been inserted into the Wildlife Camera, and the menu options
and settings cannot be accessed.
NOTE: If the micro SD card is full then the camera will not take any more photos/
videos unless ‘Loop Recording’ has been selected from the 'Recording Modes and
Settings Menu' section starting on page 21.
To Next Page
Loading...
