ak 3.11
17
Important!: The motor is fixed to the motor support with precote®-coated screws. Should it become
necessary to replace the motor the screws have to be warmed with a hot air fan to 80°C maximum.
7.3. Rocker lever and reset
5. Remove washer (Pos.163). To do so, retain
the excentric axe (Pos.155) with a 5mm
wrench on its back side and loosen the screw
(Pos. 164).
6. Pull out the toothed belt wheel (Pos. 127).
Remove screw (Pos.102) and retaining rings
(Pos. 74). The cover of the motor support (Pos.
126) can now be removed.
1. Remove retaining rings (Pos. 66 & 74).
Loosen the blocking pawl with a screw
driver and pull it off the lever. Remove the
To Next Page
Loading...
