AP10
Safety information English
AP10 · Date 10.01.2020 · Art. No. 86832 · Mod. status 6/20
25
Important operating information that may facilitate operation or cause
unplanned device reactions if disregarded including possible property
damage.
Signal si symbols gns
2.3 Target group
Installation instructions and User manual are intended for the configura-
tion, commissioning and mounting personnel of plant or machine manu-
facturers. This group needs profound knowledge of an position indicator's
necessary connections and its integration into a complete machinery.
Insuciently qualified personnel
Insuciently qualified personnel cause personal injury, serious damage to
machinery or position indicator.
` Configuration, commissioning, mounting and maintenance by trained
expert personnel only.
` This personnel must be able to recognize danger that might arise from
mechanical, electrical or electronic equipment.
Qualified personnel are persons who
• are familiar with the safety guidelines of the electrical and automation
technologies when performing configuration tasks;
• are authorized to commission, earth and label circuits and devices/
systems in accordance with the safety standards.
2.4 Basic safety information
Danger of explosion
` Do not use the position indicator in explosive zones.
Rotating parts
Bruising, rubbing, abrasing, seizing of extremities or clothes by touching
during operation any rotating parts as for example clamping ring, torque
support or hollow shaft.
` Install protective facilities to prevent people from getting access.
NOTICE
WARNING
DANGER
WARNING
To Next Page
Loading...
Need help?
General
