EasyManuals Logo

Silicon Graphics Octane III User Manual

Silicon Graphics Octane III
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
Upgrading or Replacing Components
007-5633-001 11
PCIe cards
Disk drives
System fans
Power supplies
Service personnel should use the procedures in the guide to upgrade system components or replace
failing components.
Warning: If a lithium battery is installed in your system as a soldered part, only SGI
qualified service personnel should replace this lithium battery. For a battery of another type,
replace it only with the same type or an equivalent type recommended by the battery
manufacturer, or an explosion could occur. Discard used batteries according to the
manufacturer’s instructions.
Octane III Cluster Server Cooling
The SGI Octane III server is cooled using 12 fans (six on the front and six on the rear). The six
front fans push air into the enclosure while the rear six fans pull it out the back.
The system fan assemblies are located behind the front and rear panels on the enclosure.
Figure 1-5 on page 12 illustrates the fan locations on the system.

Table of Contents

Other manuals for Silicon Graphics Octane III

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Silicon Graphics Octane III and is the answer not in the manual?

Silicon Graphics Octane III Specifications

General IconGeneral
BrandSilicon Graphics
ModelOctane III
CategoryServer
LanguageEnglish

Related product manuals