How To Change the Configuration Data
007-5633-001 31
This feature displays "Press DEL to run Setup" during POST. The options are Enabled and
Disabled.
Interrupt 19 Capture
Interrupt 19 is the software interrupt that handles the boot disk function. When this item is set to
Enabled, the ROM BIOS of the host adaptors will "capture" Interrupt 19 at boot and allow the
drives that are attached to these host adaptors to function as bootable disks. If this item is set to
Disabled, the ROM BIOS of the host adaptors will not capture Interrupt 19, and the drives attached
to these adaptors will not function as bootable devices. The options are Enabled and Disabled.
Power Configuration
Power Button Function
If set to Instant_Off, the system will power off immediately as soon as the user hits the power
button. If set to 4_Second_Override, the system will power off when the user presses the power
button for 4 seconds or longer. The options are Instant_Off and 4_Second_Override.
Restore on AC Power Loss
Use this feature to set the power state after a power outage. Select Power-Off for the system power
to remain off after a power loss. Select Power-On for the system power to be turned on after a
power loss. Select Last State to allow the system to resume its last state before a power loss. The
options are Power-On, Power-Off and Last State.
Watch Dog Timer
If enabled, the Watch Dog Timer will allow the system to reboot when it is inactive for more than
5 minutes. The options are Enabled and Disabled.
Processor and Clock Options
This submenu allows the user to configure the Processor and Clock settings.
Ratio CMOS Setting
This option allows the user to set the ratio between the CPU Core Clock and the FSB Frequency.
(Note: if an invalid ratio is entered, the AMI BIOS will restore the setting to the previous state.)
The default setting depends on the type of CPU installed on the motherboard. The default setting
To Next Page
Loading...
Need help?
General
