48 007-5633-001
4: Octane III Workstation BIOS Information
Parameter Selector
Use this feature to select the parameter of your Mac Address configuration.
Mac Address
The BIOS will automatically enter the Mac address of this machine; however it may be
over-ridden. Mac addresses are 6 two-digit hexadecimal numbers (Base 16, 0 ~ 9, A, B, C, D, E,
F) separated by dots. (i.e., 00.30.48.D0.D4.60).
Current Mac Address in BMC
This item displays the current Mac address used for your IPMI connection.
Subnet Mask Configuration
Subnet masks tell the network which subnet this machine belongs to. The value of each three-digit
number separated by dots should not exceed 255.
Parameter Selector
Use this feature to select the parameter of your Subnet Masks con.guration.
Subnet Masks
This item displays the current subnet masks setting for your IPMI connection.
SEL PEF Configuration
Set PEF Configuration
Set this feature to configure the Platform Event Filter (PEF). PEF interprets BMC events and
performs actions based on pre-determined settings or 'traps' under IPMI 1.5 speci.cations. For
example, powering the system down or sending an alert when a triggering event is detected.
The following will appear if PEF Support is set to Enabled. The default is Disabled.
PEF Action Global Control -These are the different actions based on BMC events. The options are
Alert, Power Down, Reset System, Power Cycle, OEM Action, Diagnostic Interface.
Alert Startup Delay - This feature inserts a delay during startup for PEF alerts.
To Next Page
Loading...
Need help?
General
