What to do if my Silicon Graphics Server will not power on?
First, ensure that the power cords are properly seated in the power receptacles. Next, check that the enclosure’s enable power switch is set to the On (|) position. If the problem persists, contact your support organization or SSE.
What to do if the Fault LED of a populated PCI slot is illuminated on my Silicon Graphics Server?
Reseat the PCI card. If the fault LED remains on, replace the PCI card.
Why system console does not display after boot on Silicon Graphics Server?
Check the monitor connection to both the power source and the video connector on the back of the system. If your monitor is plugged into a DVI-I connector, ensure that your system's graphics option supports it; if it does not, use the VGA connector instead.
General| Clock Speed | Up to 3.33 GHz |
|---|---|
| Networking | Gigabit Ethernet |
| Processor | Intel Xeon |
| RAM | Up to 192 GB |
| Storage | SATA or SAS |
| Graphics | NVIDIA Quadro |
| Operating System | SUSE Linux Enterprise Server |
| Expansion Slots | PCIe slots |
To Next Page
