Silvercrest SFPM 600 A1 User Manual

34
GB
~ Note the information in these user in-
structions on the maximum filling vol-
umes, maximum ingredient quantities,
maximum operating times and the rec-
ommended speed settings.
~ Do not overfill the blender jug and the
working container, otherwise the con-
tents may be ejected. Overflowing liq-
uid would flow onto the surface. You
should therefore place the device on a
waterproof surface.
~ Do not exert too much pressure on the
grater and cutting disc. Apply an even
pressure so that the motor does not be-
come blocked.
~ Do not operate the device when it is
empty, as this causes the motor to over-
heat and may result in it becoming dam-
aged.
~ Only use the original accessories.
~ Do not use any astringent or abrasive
cleaning agents.
~ The device is equipped with non-slip
plastic suction feet. As furniture is coat-
ed with a wide array of varnishes and
plastics and is also treated with different
care products, it cannot be fully ruled
out that some of these materials contain
ingredients that could attack and soften
the non-slip plastic suction feet. If neces-
sary, place a non-slip mat under the de-
vice.
~ Never fill the blender jug with hot or
boiling material.
4. Items supplied
1 multifunction food processor, base
unit12
1axle9
1 adapter7
1 working container8 with
-lid3
- food pusher1
1 whisking disc17
1 mixer assembly4
1 blade assembly5 with blade guard6
1 grater and cutting disc16
1blender jug13 with
-lid14
- mini measuring cup15
1 copy of the user instructions
5. Unpacking and
setting up
NOTE: when the device is used the first few
times, some odour may be generated by the
device due to the heating of the motor. This
is harmless. Please ensure adequate ventila-
tion.
1. Remove all packing material.
2. Check to ensure that all parts are pres-
ent and undamaged.
3. Clean the device prior to first
use! (see “Cleaning and servicing the
device” on page 46).
4. Figure A: wind the excess power ca-
ble10 around the cable spool20 on
the underside of the base unit12 and
fix it in the cable clamp19.
5. Place the base unit12 on a level, dry
and waterproof surface, so that the de-
vice can neither fall nor slip off.
Select a smooth, clean surface, so that
the suction feet18 can stick firmly in
place and ensure a secure grip.
CAUTION:
~ Overflowing liquid would flow onto the
surface. You should therefore place the
device on a waterproof surface.
__355017_2004_Kuechenmaschine_B8.book Seite 34 Donnerstag, 24. September 2020 1:10 13

Silvercrest SFPM 600 A1 Specifications

General

Brand	Silvercrest
Model	SFPM 600 A1
Category	Food Processor
Language	English