Silvercrest SFPM 600 A1 - 13 Cleaning and Servicing the Device; Cleaning the Base Unit

46
GB
NOTE: stop the mixing process if the ingre-
dients are not being processed evenly
enough. Open the lid14 and push the in-
gredients from the edge to the middle with a
spatula or something similar. When mixing
dry ingredients you can also remove the
closed blender jug13 and shake it a little.
12. When the process is completed, switch
the dial11 to 0 and pull out the mains
plug10.
13. Turn the lid14 slightly in an anticlock-
wise direction and remove it.
14. Turn the blender jug13 slightly anti-
clockwise and remove it.
15. Carefully remove the processed ingredi-
ents from the blender jug13.
16. Clean all of the accessories that have
been used immediately if possible.
13. Cleaning and
servicing the device
DANGER! Risk of electric
shock!
~ Disconnect the mains plug10 from the
wall socket before each cleaning.
~ Never immerse the base unit12 in wa-
ter.
DANGER! Risk of injury from
cutting!
~ Please note that the blades of the blend-
er jug13, the blade assembly5 and
the grater and cutting disc16 are very
sharp. Never touch the blades with your
bare hands in order to avoid cuts.
WARNING! Risk of material damage!
~ Never use any abrasive, corrosive or
scouring cleaning agents. These might
damage the device.
NOTE: certain foods or spices (e.g. curry)
may discolour the plastic. This is not a de-
vice error and is harmless to health.
13.1 Cleaning the base unit
1. Clean the base unit12 with a damp
cloth. You can also use a little deter-
gent.
2. Then wipe off with a clean, moist, light
cloth with clean water.
3. Do not use the base unit12 until it is
completely dry again.
__355017_2004_Kuechenmaschine_B8.book Seite 46 Donnerstag, 24. September 2020 1:10 13