37
GB
7.3 Safety functions
In order to minimise the risk of injury, the
food processor can only be started if certain
accessories have been assembled correctly.
DANGER! Risk of injury!
~ Never bypass the safety functions!
The principle: marking
z
+
/
Wherever you see the lock symbols and a
dot, the same principle applies.
1. Placing the upper accessory in
position:
Mount the upper accessory with the
z
marking pointing to the open lock
symbol .
2. Turning clockwise:
Turn the upper accessory clockwise until
it clicks into place.
3. Correctly assembled:
When the accessories have been cor-
rectly assembled, the
z
marking points
to the closed lock symbol .
• In order to remove this, turn the upper
accessory anticlockwise until the
z
marking points to the open lock
symbol . You can then lift off the ac-
cessory.
Lid14 of the blender jug13
There is a lock symbol / on the lid14
for mounting the lid to the blender jug13.
The blender jug has no marking on the top.
1. Place the lid14 on with a slight offset
(see illustration).
2. Turn the lid14 clockwise (towards the
closed lock symbol
) until it clicks into
place.
• To remove, turn the lid14 anticlockwise
(in the direction of the open lock
symbol ) until you can lift the lid14
upwards.
NOTE: you can remove the food pusher1
and the mini measuring cup15 while the
device is running.
__355017_2004_Kuechenmaschine_B8.book Seite 37 Donnerstag, 24. September 2020 1:10 13
To Next Page
Loading...
Need help?
General
