English -25
If you have selected UPDATE FROM NETWORK, configure your time
zone in the next dialogue window.
Then configure the automatic setting for summer/winter time to ON or OFF.
If you have selected the last option (NO UPDATE), proceed as follows to set the time
manually:
The digit position for the day flashes.
Set the day using and press SELECT to confirm.
The digit position for the month flashes.
Set the month using and press SELECT to confirm.
The digit position for the year flashes.
Set the year using and press SELECT to confirm.
The digit position for the hour flashes.
Set the hour using and press SELECT to confirm.
The digit position for the minutes flashes.
Set the minutes using and press SELECT to confirm.
12.2. Maintaining the network connection
If the network connection is to remain active even when in standby mode or in
operating modes that do not use WLAN such as AUX IN or FM radio (increasing power
consumption in standby mode), select YES. When you press YES to confirm this setting,
the internet and network functions are available more quickly when the device is switched
on.
When NO is set, the network connection is re-established when the internet radio is
switched on after having been on standby.
12.3. Establishing a connection to a network
The names (SSID) of the networks found are shown in a list. WLAN access points that
provide a connection via WPS are indicated with [WPS].
Beneath this, you will see:
RESCAN: start a new search
MANUAL CONFIG: enter connection data manually
12.3.1. Connection via WLAN:
Select the WLAN access point for connection with the internet radio and press SELECT
on the remote control to confirm.
In case of an unencrypted (open) WLAN Access Point, the internet radio establishes the
connection automatically.
To connect with an encrypted network, observe the following sections.
IAN 359937 LB8-ML 5006 8137 QSG-Content final rev4 (V7).indb 25IAN 359937 LB8-ML 5006 8137 QSG-Content final rev4 (V7).indb 25 08.12.2021 13:12:0708.12.2021 13:12:07
To Next Page
Loading...
