Silverline 580430 - Troubleshooting; Tool operating slowly; Tool seized; Strong vibrations when tool is switched on

EN
8
Problem Possible Cause Solution
Tooloperatingslowly
Pressure incorrect Setthecorrectairpressureaccordingtothespecication
Dirtwithinthemechanism Pour oil into air inlet as per maintenance instructions
Air blockage Operate tool in short bursts to clear blockage
Air leak
Checkallttingsandhoseforairleaksandcorrectissuebyre-tightening,
usingPTFEtapeorreplacing
Blockageingauzemeshlter RemoveQuickConnector(5)andcleanmeshlter
Tool seized
Dirt or rust in mechanism Try'Tooloperatingslowly'solutions
Dirt or rust in mechanism Taptoolgentlywithasoftmallet
Dirt or rust in mechanism Freemechanismbyrotatingdrivemanuallywhendisconnectedfromairline
Strongvibrationswhentoolis
switchedon
Sandingdiscincorrectlyattachedordamaged Reattach or replace sanding disc
BackingPad(6)damaged Replace Backing Pad
Spindle bent HavethetoolrepairedbyanauthorisedSilverlineservicecentre
Toolwillnotstopaftertriggeris
fullyreleased
Throttle valve O-ring or valve seat damaged HavethetoolrepairedatanauthorisedSilverlineservicecentre
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
Troubleshooting
580430_OwnerManual.indd 8580430_OwnerManual.indd 8 12/04/2023 11:0312/04/2023 11:03