SYSTEM OPERATIONS-65
SHIFT/THROTTLE CONTROL
SYSTEM (GLENDINNING CON-
TROLS) (OPTIONAL)
You may have chosen as an option when
you purchased your 34C, an electronically
controlled Shift/Throttle Control System,
factory installed at the Silverton plant.
The purpose of this system is to provide
the operator with smooth, positive shift
and throttle operation requiring minimal
manual effort. With this system, only one
(1) shift/throttle control lever is required
per engine; the left control lever operates
the Port engine and the right control lever
operates the Starboard engine.
The Glendinning Shift/Throttle Control
System is operated on DC electrical pow-
er, controlled by a breaker switch located
on the DC electrical Panel and described
as “Accessory” (Refer to the Electri-
cal Pages in this section of this Owner’s
Manual for the switch location).
Refer to the GLENDINNING CON-
TROLS, INC. Manual included with your
owner’s packet for additional technical
information concerning the operation
and maintenance of the GLENDINNING
SHIFT/THROTTLE CONTROL SYSTEM.
To Next Page
Loading...