Sime Brava Slim BF - Faults, Shutdown, and Maintenance Overview

50
EN
1.6 Fault / malfunction codes
If a fault/malfunction is detected during boiler operation, the
message
"ALL" will appear on the display followed by the fault
code.
If you see alarm
“02” (low water pressure in the system):
– on the display (1), check that the heating system pressure when
cold is
1-1.2 bar . If this is not the case, open the filling valve (2)
and restore the heating system pressure until the display (1)
shows a reading of
1-1.2 bar
– close the filling valve (2)
– press and hold the button
y
for more than 3 seconds and
check whether normal operating conditions are restored.
2
1
Fig. 4
If you see alarm “06” (no flame detected) and “07” (safety ther-
mostat intervention):
–
press and hold the button
y
for more than 3 seconds and
check whether normal operating conditions are restored.
If this operation is not successful, ONLY ONE MORE ATTEMPT can
be made, therefore:
– close the gas isolation valve
– set the main system switch to "OFF"
– contact the Qualified Technical Personnel.
OFF
Fig. 5
m
CAUTION
Should you see an alarm not described here, contact a
qualified technical professional
.
1.6.1 Maintenance request
When it is time to perform maintenance on the boiler, the
c
symbol shows on the display.
Contact the technical assistance service to organise the neces-
sary work.
2 SHUTDOWN
2.1 Temporary shutdown
If the user wishes to interrupt boiler operation, press and hold
the button
y
for at least one second, once if in "WINTER mode"
n
or twice if in "SUMMER mode"
l
.
"- -" will appear on the display.
f
ELECTRICAL HAZARD
The boiler will still be powered.
If the user is away temporarily, for a weekend, short trip etc and
if the outside temperature is at ZERO:
– press and hold the button
y
once if in "WINTER mode"
n
or
twice if in "SUMMER mode"
l
to put the boiler into stand-by
– set the main system switch to "OFF"
– close the gas valve.
OFF
Fig. 6
m
CAUTION
If the outside temperature might fall below ZERO, since
the appliance is equipped with an "antifreeze function"
– ONLY PUT THE BOILER INTO STAND-BY
– leave the main system switch set to "ON" (boiler is
powered)
– leave the gas valve open.