Sime Brava Slim BF - Page 80

80
EN
– keep the button
t
pressed and scroll through the parameters
until reaching parameter "03"
– press the button
>
and select "1" (LPG)
Procedure which MUST be carried out after:
–
the nozzles for gas conversion
– changing the gas valve following a fault
– changing the the electronic board following a fault
– electrode
– fan
– burner
– go into the parameter section (if not already there) by press-
ing the buttons
r
and
t
(for approximately 5 seconds) at the
same time until
"PAR 01" (parameter number) and the value
set (0-4) appears on the display
– keep the button
t
pressed and scroll through the parameters
until reaching parameter
"PAR 49"
– press and hold the button
>
to set the value at "49"
– the modified value will be stored automatically
– keep the button
t
pressed and scroll through the parameters
until reaching parameter
"PAR 70"
– press the button
>
to set the value at "5"
– the modified value will be stored automatically
– exit the parameter section by pressing and holding down the
buttons
r
and
t
at the same time (approximately 5 seconds)
until the delivery temperature is displayed.
m
IMPORTANT
To complete this task the user MUST carry out the fol-
lowing procedure.
Adjusting maximum gas pr
essure:
– press the button
y
until "SUMMER" mode
l
has been se-
lected
–
press button
r
and set the DOMESTIC HOT WATER SET to
maximum using the button
>
– press and hold down the buttons
>
and
y
at the same time
for approximately 6 seconds until the message
"Au" appears on
the display alternating with
"to"
– open one or more than one hot water tap
– the boiler will start up and the message "P01" will appear on
the display (Adjusting maximum gas pressure)
– press the buttons
>
or
<
until the pressure value indicated in
the table appears on the pressure gauge
– once the value indicated in the table has been reached, press
the button
y
for approximately 2 seconds to confirm the val-
ue which will then flash once.