3-1
IMPORTANT: Notify appropriate personnel (building occupants,
fire department, or monitoring facility, etc.) of the
installation. Before beginning installation, ensure that
you are thoroughly familiar with these instructions and
all applicable regulatory requirements. (Refer to
Chapter 2 - Requirements and Accessories.)
The following tools and equipment are required for 4004 installation:
• 1/4-inch Flat-Tip Screwdriver
• Volt-Ohmmeter
• Diagonal Cutting Pliers
• Wire Strippers
• End-of-Line Resistors (supplied by Simplex)
• The 841-992 Field Wiring Diagram
The installer is responsible for safeguarding all 4004 material shipped to the job
site. During system installation, store all 4004 items (including all
documentation) in a clean, dry, and safe place until needed.
1. Remove the back box from the shipping container and lay it on a flat
surface.
2. Using the information in Figure 2 as a reference, install the back box.
• For specific internal wiring directions, refer to Figure 2 and the
841-992 Field Wiring Diagram.
Continued on next page
Chapter 3
Installation
Requirements
Back Box
To Next Page
Loading...
Need help?
General
