36 | Connect Simrad GB40 or Northstar 8000i
Ethernet crossover cable
Used to connect the radar processor directly to a NavComputer. Cable has female connectors on both ends
and joins two of the above standard ethernet cables together
AA010084
Optional parts to connect (GB40 only)
24006694
AT10-HD
This is used to supply the
radar processor with heading
information at 10 Hz from a
SimNet heading source. This is
needed for MARPA and
accurate chart overlay. This
connects to the 12 pin NMEA /
COMMS connector on the radar
processor.
Optional parts to connect (GB40 and 8000i) utility cable
AA010070
This is used to supply the radar
processor with NMEA 0183 heading
information at 10 Hz from an
NMEA 0183 heading source. This
connects to the 12 pin NMEA /
COMMS connector on the radar
processor.
To Next Page
Loading...
Need help?
General
