CP42/50/52 Miscellaneous menu Chapter 8
89
DataCard status
1
Press [1] to find out what data (if any) is stored on the DataCard
The capacity is divided into two databanks: DATABANK 1 and 2
whichcanholdapprox.2x450Kbdata.Togglebetweenthetwo
databanks with the +/- zoom keys.
Save on DataCard
3
Press [3] to call up a new INFO window where you can see which data
will be transferred i.e. how many routes, waypoints, etc. and how much
space it will take up in bytes + percentage of max. storage capacity.
Choose which databank you wish to transfer the data to (use the +/-
zoom keys).
The actual date and time will be saved with the data transfer.
A name can be added for easy identification later on.
ENT
Press [ENT] to activate ‘Save on DataCard’
) You will now receive a warning that existing data on the DataCard,
in the databank you have chosen, will be overwritten. You can not ‘add
more information’ to data already transferred. Whenever transferring
data either from an XX42/50/52 to Databank 1 or 2 on DataCard, or
from Databank 1 or 2 on DataCard to an XX42/50/52, the data package
will replace the entire capacity in the receiving unit, except when a
TL50 Turbo Loader is connected to the unit, then you can decide how
much data you want to transfer - refer to TL50 manual.
Load from DataCard
9
Press [9] to call up a new INFO window where you can see which data
is stored in Databank 1 or 2 on the DataCard - see example of display
on next page, without TL50 connected.
+/-
Use the +/- zoom keys to toggle between DATABANK 1 and 2
ENT
Press [ENT] x 2 to transfer a copy of the data in DATABANK 1 to the
internal memory in the unit. Any existing data in the internal memory
will be overwritten, except when a TL50 Turbo Loader is connected to
the unit, then you can decide which data should be overwritten - refer
to TL50 manual
To Next Page
Loading...
Need help?
General
