To Next Page

To Previous Page

4 Bearing to next routepoint

5 Bearing line with allowed off course limit

When travelling on a route the bearing line shows the

intended course from one waypoint towards the next.

When navigating towards a waypoint (cursor position, MOB

or an entered lat/lon position), the bearing line shows the

intended course from the point at which navigation was

started towards the waypoint.

6 Vessel symbol

Indicates distance and bearing relative to the intended

course. If the XTE (Cross Track Error) exceeds the defined XTE

limit, this is indicated with a red arrow including the

distance from the track line.

Navigate to cursor position

You can start navigating to a cursor position on any chart, or

Echosounder panel.

Position the cursor at the selected destination on the panel, and

then select the Goto Cursor option in the menu.

Note: The Goto Cursor menu option is not available if you

are already navigating.

Navigate a route

You can start navigating a route from the chart panel or from the

Route dialog.

When route navigation is started, the menu expands and shows

options for canceling the navigation, for skipping a waypoint, and

for restarting the route from current vessel position.

Navigating | GO XSE Getting Started

Simrad GO12 XSE Getting Started

Other manuals for Simrad GO12 XSE