Simrad HALO 5000 - Module Indicators and Heat Pipe; Transceiver Module Power LEDs; Ethernet LEDs; Heat Pipe Assembly

PAGE | 18
Transceiver module power LEDs
On the port side of the radar, the green and red LEDs within the left side of the transceiver module are illuminated to
indicate the module is powered.
Ethernet LEDs
Green LEDs on the R5000 processor Ethernet port indicate data communication.
Heat pipe
The heat pipe is preassembled and attached to the transceiver module. Do not disassemble or remove from the
transceiver module from the transceiver module. Loosen and remove screws from the pedestal thermal ange via the
starboard side of the pedestal. Apply thermal paste and tighten to the pedestal thermal ange.