PAGE | 8
General cleaning
Internal cleaning is only necessary when there is visible buildup of dirt.
• Use isopropyl alcohol if necessary.
• Use a soft cloth to dry damp surfaces.
Final steps
1 Grease the fastening screws to prevent corrosion and ease future removal.
2 Apply a small amount of silicone grease to the O-ring to refresh the water sealing.
3 Secure the endcaps in place.
4 Switch the safety switch to the ON position.
5 On the electric switchboard, set the radar main breaker to ON and remove the card reading:
“WORK IN PROGRESS - DO NOT SWITCH ON”.
6 On the R5000 PSU, switch the power switch to the ON position and remove the card reading:
“WORK IN PROGRESS - DO NOT SWITCH ON”.
To Next Page
Loading...
