Simrad IS20 Combi - 3 The Log;Timer Functions; The Timer Function

The log/timer functions | 17
3 The log/timer functions
The timer function
The timer function is used to measure time and distance
after a race start.
When a timer page is displayed,
basic key operation is replaced by
functions indicated by softkeys.
The timer is by default shared between interconnected
SimNet units, and all timer values will be identical. The
units can however be set up in separate SimNet Display
groups as described on page 23.
The softkey functions are further described in the
following pages.
Setting the countdown time
Range Change per step Default value
20 min - 1 1 min 5 min
If the countdown time is set to OFF, the timer function
will work as a passage log and timer!

