38 | Using radar
7. To view or change items in the installation menu for a particular radar source, the
radar source must first be selected, as shown below:
Broadband 4G
TM
Radar operation
Dual Range
When connected to a Broadband 4G™ Radar, it is possible to run the radar in Dual Range
mode. The 4G radar will appear in the radar sources menu as two virtual radar sources A
and B. Range and radar controls for each virtual radar source are fully independent* and
the source can be selected for a particular chart or radar panel in the same manner as
dual radar described in the previous section.
MARPA is fully independent and up to 10 targets may be tracked for each virtual radar
source.
Up to two independent Guard Zones may also be defined for each virtual radar source.
*Some controls that are related to physical properties of the radar itself are not
independent of source. These are Fast Scan, Antenna Height and Bearing alignment.
To Next Page
Loading...
