Simrad NSS evo2 series - Attaching the Transducer

| 9
Hardware installation | NSS evo2 Installation Manual
Attaching the Transducer
Due to the large range of transducer options, it is not practical to cover all scenarios here.
Please refer to the documentation included with the transducer for directions on physical
installation.
!
Warning: Most transducer installations require drilling holes below the vessel
water line. Incorrect installation methods could result in water ingress in to the bilge
or in to laminations of the hull material. The results could be damaging to the ves-
sel or dangerous to people aboard. Amateur installers are strongly recommended to
consult with a professional installer or boat builder.