18 |
Software setup | NSS evo2 Installation Manual
Software setup
The NSS evo2 requires some initial configuration before use, in order to get the most out of
the product.
The following sections focus on settings that typically will not require change once
configured. User preference settings and operation are covered in the operator manual.
Pressing the home key brings up the home page, which has three distinct panels.
The scrollable left column of icons access most settings that require configuration;
First time startup
When the NSS evo2 is started for the first time, or after a factory default, the unit will raise
prompts requesting the user to select some fundamental setup options;
Choose language.
Initiate source selection for data sources both internal and external to device.
Check all external data sources and NMEA 2000 data bus are turned on.
Simulation uses recorded data to allow product demonstration of features otherwise not
possible without physical installation on a vessel.
To Next Page
Loading...
