8 –EN
SPOOL PINS
HORIZONTAL SPOOL PIN for nor-
mal thread spool
Place thread spool on the pin and secure
with a spool cap to ensure smooth ow of
thread. If the thread spool has a thread re
-
taining slit, it should be placed to the right.
AUXILIARY SPOOL PIN for large
thread spool
Attach the auxiliary spool pin. Place a
spool of thread on the spool pin. The
spool pin cap is not used with the auxiliary
spool pin.
PRESSER FOOT LIFTER
1. Lower the presser foot to sew.
2. Raise the lifter to the middle position to
insert or remove fabric.
3. Lift it to its highest position to change
the presser foot to insert or remove
thicker fabric.
FEED TEETH CONTROL
The feed teeth control the movement of
the fabric that is being sewn. Feed teeth
should be raised for all general sewing
purposes and lowered for darning, free-
hand embroidery and monogramming so
that you, not the feed teeth, are guiding
the fabric.
Note: To re-engage the feed teeth, move
the lever to its raised position, then turn the
handwheel one full revolution.
Spool
Auxiliary spool
pin
Spool pin cap
Thread retaining slot
Spool
Spool
pin
To Next Page
Loading...
