19
Bobbin winder is moved to right (operating position) during sewing.
➡
Check bobbin winder and move it to left.
Buttonhole lever is not lowered or raised.
➡
Lower buttonhole lever when sewing buttonholes.
➡
Raise buttonhole lever when sewing stitch patterns.
Foot control plug is pulled out, while operating foot control.
➡
Push in foot control plug.
Machine is locked up due to thread entangled with bobbin case or rotation
interrupted forcibly.
➡
Turn off power switch and eliminate the problem that caused the
machine to stop.
Reverse/tacking stitch button is pushed, while buttonhole stitch is selected.
➡
Tacking stitch is made automatically after buttonhole stitch is completed.
It is not necessary to push the reverse/tacking stitch button.
Bobbin winder is in operation.
➡
Move bobbin winder to left when it is not used.
If an incorrect operation is made, a helpful message will be displayed. When a helpful
message is displayed, x the problem following the instructions below.
HELPFUL MESSAGES
To Next Page
Loading...
