1) Cutting tool in place A.
2) Key
3) Move the cutting tool to place B.
4) Key
Notes: A lit “DIR” indicator means diameter display, Z/Z
0
axis is not able
to display so.
7. “M/I” (metric/British system) Switch Display
Press the button to switch between the
Metric and British measurement systems.
1) To repair a spare part with British
measurement system, the original metric
display has to be changed to British system display.
2)Key
3) Move, drag and start the cutting tool
until the axle display turns out 2.
4) Key
8. Linear Error Compensation
The linear error compensation function is used to make the linear
correction of the system error of the grating metering system.
Correction factor S=(L-L')/(L/1000)mm/m
SEL
SEL
SEL
SEL
SEL
SEL
SEL
To Next Page
