SINO SDS2-2MS - PCD Circle Equally Dividing Holes Function

subsidiary zero position. The point at which the resetting operation act become
the new subsidiary zero position, and the new subsidiary zero position
replacing the original subsidiary zero position.
3. Turn to one half during a subsidiary zero position is being used
“1/2” function may be used under UCS display mode. Turning to one
half under the UCS display mode using a subsidiary zero position is actually
also resetting a new subsidiary zero position. After the operation of turning to
one half act, the original subsidiary zero position will be replaced by the new
subsidiary zero position is center between the original subsidiary zero position
and the point at which the operation act.
F.
PCD Circle Equally Dividing Holes
(Be the same with: 2-2M
t
tt
t
2-2MS
t
tt
t
2-3M
t
tt
t
2-3E)