© Nov. 2020 3-10 GTTZ10EJ Operation Manual
SAFETY
BATTERY HAZARD
• Only the properly trained
personnel authorized by the
workplace are allowed to remove
the battery from the machine.
• Before replacing the battery, be
sure to identify the appropriate
number of personnel and the
lifting method.
• During the assembling or
disassembling process, never use
the battery in a forciable manner,
and never allow the battery to fall
off.
• Never directly short-circuit the
battery outputs with electrical
cords.
• Should the battery acid spill out,
use bicarbonate (baking soda)
mixed with water to neutralize the
acid.
• Never store the battery in water or
humid atomosphere.
• Daily check the battery cable for
damage, and replace any
damaged parts before operating
the machine.
• Do not expose the battery or
charger to water/rain during
charging.
NOTICE
After charging the battery, be sure that:
• The battery cable connections are free of
corrosion.
• The battery hold-down and cable connections are
secured.
Adding terminal protection and anti-corrosion
sealants will help reduce corrosion of the battery
terminals and cables.
WELDING AND POLISHING
REQUIREMENTS
Before welding, grinding and polishing operations, al-
ways ensure you read and understand all operation and
maintenance requirements in this manual and the Main-
tenance Manual.
WELDING HAZARDS
• Comply with the welder manufac-
turer’s recommendations for pro-
cedures concerning proper use of
the welder.
• Welding leads or cables may only
be connected after turning off the
power unit.
• Carry out welding operations only
after the welding cable has been
correctly connected.
• Do not use the machine as a
ground wire during welding
operation.
• At all times, make sure that the
power tools are completely stored
in the working platform. Do not
hang the power tools on the rail-
ing of the working platform or the
work area outside the working
platform, or hang the power tools
directly by the wire.
Before performing welding, grinding and polishing work,
welders must seek permission of the responsible de-
partment at the workplace.
LOCKOUT AFTER EACH
USE
1. Choose a safe parking location that is on sturdy,
level ground and that is free of obstructions and
heavy traffic.
2. Lower the mast to stowed position.
3. Push in the emergency stop button at ground
controls to the OFF position.
4. Push in the emergency stop button at platform
controls to the OFF position.
5. Turn the key switch at the ground controls to OFF
position and remove the key to avoid unauthorized
operation of the machine.
6. Turn off the power disconnect switch.
7. Charge the battery.
To Next Page
Loading...
