GTTZ10EJ Operation Manual 5-1 © Nov. 2020
5 PRE-OPERATION INSPECTION
UNSAFE OPERATION HAZARD
Be sure to follow the instructions and
safety rules in this manual. Failure to
follow the instructions and safety
rules in this manual may result in
death or serious injury.
Do not operate this machine unless
you have learned and practiced the
rules for safely operating the ma-
chine as stated in this manual.
• Know and understand the safety
rules before continuing the next
step.
• Avoid dangerous situations.
• Always check the machine before
operating.
• Select appropriate machinery and
personal protective equipment
(hard hats, safety belt and gloves,
etc.) for the task.
• Always perform a pre-operation
inspection.
• Always perform a pre-operation
function test before using the
machine.
• Check the work site.
• Check the safety decals/ name-
plates on the machine.
• Only use the machine according
to the instructions in this manual
and for its intended purpose.
TIPS FOR CONDUCTING A
PRE-OPERATION
INSPECTION
TIPPING HAZARD
Do not change or modify the aerial
work platform without the prior
written permission of the
manufacturer. If an additional
device is installed on the platform
or guardrail for placing tools or
other materials, this will increase
the platform weight and surface
area or increase the load.
• The operator is responsible for performing the “pre-
operation inspection” and routine maintenance as
stated in this manual.
• Before each shift change, the operator must
conduct a pre-operation inspection to find out
whether the machine has obvious problems before
the operator performs a pre-operation function test.
• The pre-operation inspection also helps the
operator determine whether the machine requires
routine maintenance.
• Please refer to Inspecting Parts, page 5-2 and
check each item.
• Never use a machine that has damaged or modified
parts. Mark the machine and stop using the
machine if you discover damage or modifications.
• Only qualified maintenance technicians can repair
the machine according to the manufacturer's
regulations. After any maintenance, the operator
must perform another pre-operation inspection
before conducting a pre-operation function test.
• Qualified maintenance technicians must perform
regular maintenance inspections according to the
requirements in the manufacturer’s Maintenance
Manual.
To Next Page
Loading...
