MK15 User Manual V1.4
3
2023 SIYI Technology, All Rights Reserved
Before starting the operation, be sure to check the power of the remote controller and
the power supply voltage of the air unit.
When finishing the operation, first power off the air unit and then the remote controller.
Before setting the remote controller parameters, be sure to power off the engine and
motor to prevent accidental start.
Before starting the operation, be sure to pre-set the fail-safe function on the remote
control or in the ground station software.
When installing, please avoid installing the air unit and GPS module too close to avoid
interference. It is recommended that the distance between the air unit and the GPS module
be longer than 20 cm.
Battery
MK15 remote controller is equipped with a built-in and chargeable Li-on battery.
Please do read the precautions below before using.
The remote controller cannot be charged when it is powered on. Before charging the
remote control, please turn off the remote control.
If you find that the battery is smoking, overheating, or bulging, please stop using it
immediately.
If you find smoke or a strange smell coming from the remote controller, please stop
using it immediately and contact your reseller or SIYI after-sales service center directly.
If the remote controller overheats (above 60 degrees Celsius), please stop using it
immediately and cut off the power supply.
To Next Page
Loading...
Need help?
General