SKF KFG User Manual

Page 45
EN
KFGS
KFG
KFGC
4.7 Progressive system ventilation4.6 Fill level control for pump unit
Visual
The transparent lubricant reservoir allows for

on a regular basis for safety reasons.
The entire system must be ventilated if
the reservoir has been emptied below
the "min" mark.
Automatic
Pumps of the KFGS series allow for automatic

"min" mark, the lubrication process is stopped

display.
Fill pump with lubricant.
Remove main lines on unit.
Allow pump to run until lubricant without
bubbles is discharged at the straight con-
nector on the pump element.
Mount main lines.
Allow pump to run until grease can be seen
discharging at all lubrication points.
4.8 Single-line system ventilation
Fill pump with lubricant.
Remove main lines (pressure relief valve as
necessary) on unit.
Allow pump to run until lubricant without
bubbles is discharged at the straight con-
nector.
Mount main lines.
Remove screw plug or pressure switch at
end of main and branch lines.
Allow pump to run until air is no longer
discharged at the end of the spool pieces.
Mount screw plug or pressure switch.
Vent lubrication lines and lubrication points
and inspect for proper function.
Assembly instructions

SKF KFG Specifications

General

Brand	SKF
Model	KFG
Category	Water Pump
Language	English