29
A lubrication point gets too little lubricant or nothing at all
Operation disturbance Cause of operation
disturbance
Solution
The rotation of the bearing
makes noise, is trembling or
the temperature is rising.
The dosage adjustment of
the doser is too small.
Increase the dosage.
Doser does not operate The lubrication point has
clogged.
Lubrication pipe or hose has
clogged.
The doser is damaged.
Clean the lubrication point.
Clean or replace
lubrication pipe or hose.
Replace the doser.
Grease leakage in the area of
lubrication piping.
Lubrication piping between
the doser and lubrication
point is damaged.
Check and repair the
lubrication piping.
A lubrication point gets too much lubricant
Operation disturbance Cause of operation
disturbance
Solution
Considerable grease leakage
in the lubrication point.
The temperature of the
bearing rises.
The dosage adjustment of
the doser is too large.
The doser is damaged.
Adjust the dosage to a
smaller amount.
Replace the doser.
Warnings
Caution The lubrication disturbances of the critical lubrication points must be re-
paired immediately, since inadequate lubrication rapidly damages the
equipment or machinery being lubricated.
Note In the event that the operation disturbance can not be repaired with the
help of these instructions, please contact the supplier immediately.
To Next Page
Loading...
Need help?
General
