Information concerning EC Declaration of Conformity and EC Declaration of Incorporation Page 5
EN
The product
Piston pump with/without reservoir
of the series:
P.., PE.., PEF.., PEU.., PEW..
PF.., PFH.., PFP.., PFW.., PFPW..
PPU.., PHU.., PW..
204-.., 205-..
is hereby confirmed to comply with the essential
protection requirements stipulated by the following
Directive(s) of the Council on the approximation of
laws of the Member States:
o Machinery Directive 2006/42/EC
o Electromagnetic Compatibility 2004/108/EC
Notes:
(a) This declaration certifies compliance with the
aforementioned Directives, but does not
constitute a guarantee of characteristics.
(b) The safety instructions in the documentation
included with the product must be observed.
(c) The commissioning of the products here
certified is prohibited until the machine, vehicle
or similar in which the product is installed
conforms with the provisions and requirements
of the applicable Directives.
(d) The operation of the products at non-standard
supply voltage, as well as non-adherence to the
installation instructions, can negatively impact
the EMC characteristics and electrical safety.
We further declare:
o The aforementioned product is, according to EC
Machinery Directive 2006/42/EC, Appendix II
Part B, designed for installation in machinery /
for incorporation with other machinery to form a
machine. Within the scope of application of the
EC Directive, commissioning shall be prohibited
until the machinery in which this part is installed
conforms with the provisions of this Directive.
o The aforementioned product may, with reference
to EC Directive 97/23/EC concerning pressure
equipment, only be used in accordance with its
intended use and in conformity with the
instructions provided in the documentation. The
following must be observed in this regard:
The product is neither designed nor approved
for use in conjunction with fluids of Group 1
(Dangerous Fluids) as defined in Article 2, Para.
2 of Directive 67/548/EEC of June 27, 1967.
The product is neither designed nor approved
for use in conjunction with gases, liquefied
gases, pressurized gases in solution, vapors, or
such fluids whose vapor pressure exceeds
normal atmospheric pressure (1013 mbar) by
more than 0.5 bar at their maximum
permissible temperature.
When used in conformity with their intended use,
the products supplied by SKF Lubrication Systems
Germany AG do not reach the limit values listed in
Article 3, Para. 1, Clauses 1.1 to 1.3 and Para. 2 of
Directive 97/23/EC. They are therefore not subject
to the requirements of Annex 1 of the Directive.
Consequently, they do not bear a CE marking in
respect of Directive 97/23/EC. SKF Lubrication
Systems Germany AG classifies them according to
Article 3, Para. 3 of the Directive.
The Declaration of Conformity and Incorporation
forms part of the product documentation and is
supplied together with the product.
Information concerning EC Declaration of Conformity and EC Declaration of
Incorporation
To Next Page
Loading...
Need help?
General
